You are on the takeoff ready to go. The competition theme is ready. This is the right page to use now.

For further details have a look at: Setting up a task

Starting from version 1.6.1 it is possible to set the waypoint radii individually by means of the wpt radius drop-down menu.

Race type: speed run o race to goal

This drop-down menu allows you to select the route to follow. If you still have to create the route, choose new route... from the menu to go to the route editing page.

Choose the start waypoint with this drop-down menu. Use this menu after selecting the route.

Start-type selection.

Start-pylon radius.

Cylinder radii. By opening the wpt radius drop-down menu

you can choose whether all the waypoints have the same radius or you want to set the radii individually. In the latter case, a new page will apper allowing you to enter the values.

If the start is on entry and if it must be validated also as a normal waypoint (with a 400 m radius in the figure) after its validation as a start pylon, you have to select this checkbox.

By means of these controls you can choose the goal type (cylinder, line or both) and its size.

Start opening and closing time, in hh:mm. If the task is a race to goal, the parameter dT is referred to the opening time. If the race is a speed run, dT points to the closing time.

Type of race. In the case of race to goal, the start must be validated after the time entered in the start time field.

Activates the task and shows a page with the race details. For further details, see: Setting up a task